The PS Series is a remote power supply line from FireLite Alarms and is a direct replacement for the FCPS-24FS6/8 Series. The FLPS6(C) is a 6 amp and the FL-PS10(C) is a 10 amp, remote power supply with battery charger that may be connected to any 12 or 24 volt fire alarm control panel (FACP) or used as a standalone power supply. The PS Series provides 24 VDC power for NACs (notification appliance circuits) configured as either Class B or Class A (requires the ZNAC-PS option card) with multiple sync protocol options. The PS Series also provides auxiliary power, constant or resettable, suited for detectors, annunciators, door holders, and other fire alarm system peripherals. The PS Series cabinet can hold two 7 AH or 18 AH batteries and can charge up to 33 AH batteries in a separate cabinet.FeaturesUp to five (6 amp model) or seven (10 amp model) independently-configurable, power-limited output circuits for:Class B and/or Class A NACsClass B and/or Class A resettable or non-resettable 24V auxiliary powerdoor holder powerConverts from Class B to Class A wiring without losing any outputs using the ZNAC-PS converter card (sold separately)Optimal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated powerConfigurable for ANSI? Temporal 3 or Temporal 4 coded outputUL-Listed NAC synchronization using System Sensor?, Wheelock?, Gentex?, or AMSECO? appliancesSynchronization can be triggered from FACP NAC/remote sync outputs, cascaded power supply, or a control module, single or multi, which may be housed within the power supply cabinetAbility to cascade up to four power suppliesTwo (6 amp model) or three (10 amp model) fully-isolated input/ control circuits which can be programmed to any outputTwo Form C normally-closed trouble relays for AC Trouble and General Trouble, Ground Fault relay available on Canadian models only6 or 10 amp full load output, respectively, with 3 A maximum/circuitIndividual NAC power and trouble LEDs for diagnostic efficiencyTrouble history modes for diagnostic supportWide range end-of-line supervision value (normal: 2K-27K ohms)Selectable earth fault detection (enable or disable)AC trouble report delay timerCompletely configurable via onboard DIP switches, no extra software requiredSelf-contained in compact, locking cabinet constructed of heavy gauge steel with a corrosion-resistant powder coat chip and scratch-resistant finishCabinet designed with ten double knockouts and a removable door for ease of installation and wiringIncludes integral battery charger capable of charging up to 33 AH batteriesCabinet can house two 7 AH or 18 AH batteriesBattery charger may be disabled via DIP switch for applications requiring larger batteries and external battery chargerRemovable terminal blocks accommodate up to 12 AWG (3.1mm2) wireWorks with any UL 864 FACP which utilizes an industry-standard reverse-polarity notification circuitOptional devices include addressable control, monitor, and relay modules and power-supervision relay (EOLR-1)
